Analysis of Fin Tip Temperature and Fin Efficiency for Different Fingeometries and Materials Using Abaqus

Authors

  • S. Imran Faculty of Mechanical Engineering, University of Engineering and Technology, Lahore, Pakistan
  • F. Noor Faculty of Mechanical Engineering, University of Engineering and Technology, Lahore, Pakistan
  • H. Ali Faculty of Mechanical Engineering, University of Engineering and Technology, Lahore, Pakistan
  • A. Hussain Faculty of Mechanical Engineering, University of Engineering and Technology, Lahore, Pakistan
  • Z. Ali Department of Mining Engineering, University of Engineering and Technology, Lahore, Pakistan
  • R. Shad Department of Mechanical Engineering, University of Central Punjab, Lahore, Pakistan

Abstract

Fins are widely used in various engineering applications to enhance the rate of heat transfer. The effect of fin geometry and its material on the fin efficiency and the amount of heat transferred are investigated in this study. Rectangular and triangular fin geometries have been considered and two fin materials, aluminum and carbon steel, have been selected. It is found numerically that the fin tip temperature and the fin efficiency are decreased with the increase of the convective heat transfer coefficient. ABAQUS has been used to conduct this numerical study.

References

R. Romero-Mndez, M. Sen, K.T. Yang, and R.L. McClain, Int. J.

Heat and Mass Trans., vol. 40, p. 3909, 1997.

B. Olayiwola and P. Walzel, Chemical Engineering and Processing:

Process Intensification, vol. 47, p. 929, 2008.

K.M. Kelkar and S. V. Patankar, J. Heat Trans., vol. 109, p. 25,

K. Suga and H. Aoki, J. Enhanced Heat Trans., vol. 2, p. 231, 1995.

R. Romero-Mndez, M. Sen, K.T. Yang and R. McClain, Int. J. Heat

and Mass Trans., vol. 43, p. 39, 2000.

L. Luviano-Ortiz, A. Hernandez-Guerrero, C. Rubio-Arana and

R. Romero-Mendez, Int. J. Heat and Mass Trans., vol. 51, p. 3972,

J.J. Wei and H. Honda, Int. J. Heat and Mass Trans. vol. 46, p. 4059,

J. Zhang, J. Kundu and R. M. Mangli, Int. J. Heat and Mass Trans.,

vol. 47, p. 1719, 2004.

Downloads

Published

13-03-2015

How to Cite

[1]
S. Imran, F. Noor, H. Ali, A. Hussain, Z. Ali, and R. Shad, “Analysis of Fin Tip Temperature and Fin Efficiency for Different Fingeometries and Materials Using Abaqus”, The Nucleus, vol. 52, no. 1, pp. 20–24, Mar. 2015.

Issue

Section

Articles