INVESTIGATION OF PHASES DEVELOPED IN Bi4Ti3O12 SYSTEM BY THERMAL AND ANALYTICAL TECHNIQUES

Authors

  • S. Naz Materials Division, Directorate of Technology, PINSTECH, Nilore, Islamabad, Pakistan
  • M. Shahzad Materials Division, Directorate of Technology, PINSTECH, Nilore, Islamabad, Pakistan
  • A. H. Qureshi Materials Division, Directorate of Technology, PINSTECH, Nilore, Islamabad, Pakistan
  • H. Waqas Materials Division, Directorate of Technology, PINSTECH, Nilore, Islamabad, Pakistan
  • N. Hussain Materials Division, Directorate of Technology, PINSTECH, Nilore, Islamabad, Pakistan
  • K. Saeed Materials Division, Directorate of Technology, PINSTECH, Nilore, Islamabad, Pakistan
  • L. Ali Department of Metallurgical & Materials Engineering, University of Engineering and Technology, Lahore, Pakistan

Abstract

Bismuth titanate (Bi4Ti3O12) powders were prepared by conventional mixed oxide method using oxide mixture i.e. bismuth oxide (Bi2O3) and titanium oxide (TiO3). The mixed powders were ball milled for different times (8, 16, and 24h). The phase formation was investigated by X-ray diffraction (XRD) and results revealed that milled powder was mainly consisted of phases Bi2O3, TiO2 and small amount corresponded to Bi4Ti3O12. However, after calcination at 700ºC, Bi4Ti3O12 phase was mainly observed. Thermal decomposition behavior (DSC-TGA-DTA) was investigated as a function of milling time. Thermal analysis alongwith XRD results showed that the formation of desire phase (Bi4Ti3O12) was only possible above 600ºC. Single phase Bi4Ti3O12 ceramic was obtained with the orthorhombic structure by sintering at 800ºC. Maximum density (8.61g/cm3 ) was achieved in sample milled for 24h due to reduction in particle size which ultimately enhanced the diffusion process during sintering.

References

J.F. Dorrian, R.E. Newnham and K.K. Smith,

Ferroelectrics 3 (1971) 17.

S.E. Cummings and L.E. Cross, J. Appl.

Phys. 39 (1968) 2268.

H.S. Shulman, M. Testorf, D. Damjanovic

and N. Setter, J. Am. Ceram. Soc. 79 (1996)

M. Billegas, C. Moure, J.F. Fernandez and P.

Duran, J. Mater. Sci. 31 (1996), 949.

Q. Zhou and B.J. Kennedy, Chem. Mater. 15

(2003) 5025.

T. Takenaka and K. Sakata, Jpn. J. Appl.

Phys. 5513 (1984) 1092.

M. Villegas, A.C. Caballero, C. Moure, P.

Duran and J. F. Fernandez, J. Am. Ceram.

Soc. 82 (1999) 2411.

T. Zaremba, J. Therm. Anal. Calorim. 74

(2003) 653.

T. Zaremba, J. Therm. Anal. Calorim. 92

(2008) 583.

J.W. Gilmanl, D.L. VanderHart and T.

Kashiwagi, American Chemical Society, ACS

Symposium Series 599, August 21-26,

(1994), Washington, DC

L.I. Durxin, Q.U. Xuarrhui, H. Bairyun, Z.

Xiaorzian, L.I. Song-Lin and L.I. Yrmim,

Trans. Nonferrous Met. Soc. China 11 (2001)

J.W. Medernach and R.L. Snyder, J. Am.

Ceram. Soc. 61 (1978) 494.

Y. Kan, P. Wang, Y. Li, Y. Chen and D. Yan,

Mater. Lett. 56 (2002) 910.

S.H. Michael, S. Speakman and S.T. Misture,

JCPDS-International Centre for Diffraction

Data, Advances in X-ray Analysis 45 (2002)

D. Chen and X. Jiao, Mater. Res. Bull 36

(2001) 355.

H.S. Gu and A.X. Kuang, Ferroelectrics 211

(1998) 271.

N. Pavlovic, D. Kancko, K.M. Szecsenyi and

V.V. Srdic, Process. Appl. Ceram. 3 (2009)

M.N. Rahaman, Ceramics Processing and

Sintering, Marcel Dekker, New York, (2003).

O. Yamaguchi, N. Maruyama and K. Hirota,

Br. Ceram., Trans. J. 90 (1991) 111.

Downloads

Published

17-05-2011

How to Cite

[1]
S. Naz, “INVESTIGATION OF PHASES DEVELOPED IN Bi4Ti3O12 SYSTEM BY THERMAL AND ANALYTICAL TECHNIQUES”, The Nucleus, vol. 48, no. 2, pp. 101–106, May 2011.

Issue

Section

Articles

Most read articles by the same author(s)

1 2 > >>